IPX800 V3 - Assembly and installation

The IPX800 V3 is appeared as a case which can be inserted or griped in an electric control panel while being fixed on rail DIN. The unit makes 9 modules broad, it is thus necessary to envisage place in your table to insert the IPX800 V3.
The assembly of your circuits will be done on classical screw connector blocks, allowing the tightening of wire up to 2.5² of section. Obviously any do-it-yourself or modification to use a section superior is to be prohibited for multiple reasons : you will lose all warranty of the IPX800, you are likely to allow the passage of too high currents for the outputs of the IPX800, and you risk especially a bad tightening, then exposing you to the fire risk.